STILLEN 2007-2013 Infiniti G37 / 2014-2016 Infiniti Q60 Cross Drilled & Slotted 1-Piece Rotors [Rear] (Set of 2) - NIS71006

Upgrade the rear braking system of your 2007–2013 Infiniti G37 or 2014–2016 Infiniti Q60 with STILLEN Cross Drilled & Slotted Rear Rotors, engineered as a direct-fit OEM replacement for superior stopping performance and thermal management. These 1-piece rotors maintain factory geometry for seamless installation while delivering enhanced pedal feel and consistent braking—without the need for caliper modifications.

STILLEN’s advanced rotor design optimizes heat dissipation and friction stability, providing a cost-effective solution for drivers seeking a performance edge over factory components. CAD-optimized rotor faces ensure a full pad sweep across the braking surface, minimizing hot spots, uneven wear, and grooving during spirited or repeated braking.

The combination of cross drilled and slotted geometry maximizes the strengths of both designs. Cross drilled holes promote rapid heat evacuation and water dispersion, reducing brake fade and pad glazing under sustained load. Slotted channels continuously refresh the pad surface and vent gases, ensuring consistent contact and predictable braking response. Paired with high-friction ceramic brake pads, this system improves initial bite, stabilizes pedal feel, and extends component life for daily driving or spirited use where OEM rotors may fall short.

Corrosion-resistant silver zinc coating protects the rotors from oxidation and surface degradation. Each kit arrives machine-balanced and install-ready for a straightforward rear brake upgrade.

Vehicle Fitment

Rear Rotors Only

• Infiniti G37 – 2007–2013
• Infiniti Q60 – 2014–2016

Features & Benefits

• STILLEN 1-piece cross drilled & slotted rear sport rotors
• Set of 2 rear rotors
• Direct-fit OEM replacement – no caliper modifications required
• CAD-optimized for full pad sweep and reduced hot spotting
• Cross drilled & slotted geometry improves cooling efficiency and fade resistance
• Gas venting and pad refresh maintain consistent braking torque
• High-performance ceramic brake pads included with chamfered leading edges for improved grip and low dust
• Kit-specific mounting hardware reduces noise, vibration, and premature pad wear
• Corrosion-resistant silver zinc coating protects against oxidation and surface degradation
• Cost-effective performance upgrade without a big brake conversion
• Aggressive drilled and slotted appearance over flat factory rotors
• Machine-balanced and install-ready for easy installation

Photos are representative. Actual product may vary slightly.