null

Burger Tuning Kia Stinger / Genesis G70 3.3L V6 Performance Dual Intake

$379.00
Weight:
8.00 LBS
Shipping:
Calculated at Checkout

Description

The BMS KIA Stinger Intake System is designed to dramatically improve your vehicle’s performance with a high-quality, easy-to-install solution. Featuring dual inverted cone filters from Burger Motorsports, this intake system delivers superior airflow and removes restrictions present in the factory intake. By retaining the factory cold air ducting, the heat-isolating airbox bottom, and high-flow turbo inlet fittings, it ensures your KIA Stinger gets maximum performance without sacrificing reliability.

The included stylish top half shroud protects the intake from engine heat, ensuring consistent and optimized airflow. The result is a noticeable improvement in horsepower, torque, and throttle response. Plus, the intake’s deep, aggressive sound brings out the engine’s roar, allowing you to hear every bit of power working under the hood. The more boost you run, the higher the performance gains.

The Burger Motorsports renewable inverted cone filters provide a significant upgrade over stock paper filters. These filters last the entire lifespan of your vehicle, ensuring consistent airflow with every drive. Built with a velocity stack, these filters allow smooth airflow into the intake system, increasing air intake efficiency. This design is widely used in racing applications and ensures that even under heavy driving conditions, your engine can perform at its best.

This intake system has been tested on the BMS development KIA Stinger that ran an impressive 11.9@120mph in the 1/4 mile and reached 148mph in half-mile traps, confirming its performance capabilities.

Installation is quick and easy, taking just a few minutes to install and remove. The filters are cleanable and renewable every 15,000 to 20,000 miles to ensure long-lasting performance.

Available in three stylish finishes:

  • Matte Black
  • Glossy Red
  • Glossy Black

Replacement inverted cone filters in Blue or Red are also available for purchase separately.

Optional BMS High Flow Silicone Turbo Inlets (sold separately):
Enhance your intake system further with high-flow silicone turbo inlets. These replace the factory accordion inlets, increasing airflow and improving boost response and turbo sound. Power gains of up to 10whp have been observed with aggressive tuning.

Features and Benefits:

  • Increases horsepower and torque
  • Improved throttle response
  • Enhanced engine sound
  • Includes black heat shields
  • Dual inverted cone filters for increased airflow
  • Renewable and cleanable filters
  • Easy installation and removal
  • Available in three different finishes: Matte Black, Glossy Red, and Glossy Black

Vehicle Fitment:

  • 2018+ KIA Stinger GT, GT1, GT2 3.3L V6
  • 2018+ Genesis G70 3.3L V6
    Not compatible with 2.0L 4-cylinder models.

What's Included:

  • (2) 3.5" Powder-coated aluminum intake pipes
  • (2) Renewable inverted cone filters with clamps
  • (2) Aluminum heat shields
  • (2) M6x1.0x16mm bolts
  • (2) M6 nuts
  • (4) M6 washers