null

Rogue Engineering E46 M3 Rasp Pipe

$549.95
Weight:
27.00 LBS

Description

Rogue Engineering E46 M3 Rasp Pipe

Product Detail

Rogue Engineering is proud to introduce our E46 M3 Rasp Pipe, the sensible way of ridding your car of the factory exhaust rasp.  Finally, you can truly enjoy the sound of your M3 without the annoying rasp of the exhaust at the higher RPMs found in US-model E46 M3s.

The Rogue Engineering E46 M3 Rasp Pipe is made to fit exactly like factory. Features of the unit include:

    • Fully mandrel bent tubing, no crimps or flattened areas.

 

  • 100% T-304 stainless steel construction, including flanges, internals
  • Weighs only 14.5 lbs. (factory weighs 19 lbs.)
  • Will not change ground clearance
  • Will not void factory warranty
  • Will not affect emissions
  • No permanent modifications required for installation

 

During development, Rogue Engineering was able to sufficiently tune out the factory rasp without the added expense of replacing another section of of the factory exhaust system. Because of the simplicity, installation can take as little as 20 minutes (with the car on the lift, with proper tools).
                                                                                                       

For those that looking to eliminate this tone from their E46 M3s, there are a few other choices in the marketplace.  However, the Rogue Engineering Rasp Pipe is one of the few that can truly say that performance is uninhibited by the installation of this item.  Other "muffler style" designs that use one piece units to try to achieve the same result as our product do so by lowering the cost of the item (it is cheaper to use one muffler than using two, regardless of size).  These do have negative effects, as seen in comparable products used in daily drivers.

Regardless of the exhaust system you choose, the Rogue Engineering Rasp Pipe will do its job in removing the raspy tone.

 

 

 

 

Videos Hide Videos Show Videos